![]() If we dirty the cuticles or skin, we clean with the orange stick moistened with fluidpro before catalyzing in the lamp.ġ2* To eliminate the dispersion of the TOP, we can also use the fluidpro instead of the Cleaner. We don't bend our thumbs much, but we try to lay it out as best we can.ġ0* We must not be in a hurry to see a completely covering effect right away, we last all the steps well. I recommend that it be a thin layer, otherwise, a thick layer could give problems of color duration and excessive dispersion.Ĩ* Be careful to place your hand well, so that all fingers are evenly facing under the range of the bulbs. Let's check, here too, looking at the backlight surface. We always check the backlight that the surface is all completely opaque.Ħ* Attention, after completing this process we never touch the nail again for any reason, we could fatten it again and this will create possible problems of future tightness.ħ* We do not leave any part of the nail not covered by base. We gently massage our fingers and compliments, we finished our manicure with semi-permanent!ĥ* Be careful not to leave any part of the shiny nail. 2 timer cycles (in LED lamp 120 sec.).ġ2* We take a pressed cotton square, moisten with the Cleaner and clean the surface from the dispersion of the TOP.ġ3 At this point we can apply cuticles oil, distributing a small amount on the perimeter of each nail. We make a homogeneous, thin layer and catalyze in UV lamp for 240 sec., i.e. ![]() ![]() (in LED lamp 60 sec.) THIS POINT, LET'S REPEAT IT 3 TIMES (3 layers of color)ġ1 Now we are ready to apply the TOP. Here too, we try not to dirty the cuticles and apply it in a homogeneous and subtle way. It is a thin and sticky layer caused by the excessive amount of product applied.ġ0* We apply the first layer of color ( we recommend 3 total layers). What is dispersion? Dispersion can be given by both the BASE, and the TOP. (in LED lamp 60 sec.)ĩ Now, with a DRY pad we eliminate the dispersion released by the BASE, passing it on the surface of the nail. We dry our hands well with a towel.Ģ With tronchesine, we cut the excess cuticlesģ We push the small cuticles along the perimeter of the nail, using the cuticle push or orange stickĤ We use the file (side 180) to give the preferred shape to the nailsĥ* We take the finishing block and evenly mattify the nailĦ* Now with a cotton pad moistened with fluidpro, we clean the surface of the nail from the dusty residuesĪccessories: Color - BASE - TOP - Pressed cotton pad - Cleaner - fluidpro® - UV or LED lamp - Cuticole oilħ* We apply a THIN and HOMOGENEOUS layer of BASE, taking care not to touch the cuticlesĨ* We catalyze in UV lamp for 120 sec. Nail preparation Accessories: Gloves - Lima - Tronchesina - Finishing block - Push cuticles - Pressed cotton pad - Disinfectant - fluidpro®ġ We vaporize the customer's tools and hands with the disinfectant. DOES NOT contain harmful substances:Formaldehyde, Toluene and DBP The semi-permanent LCI does not damage natural nails.Ĥ. Remove in just five minutes without EVER smoothing the nail. We recommend applying 3 layers to ensure over 3 weeks of absolute perfection and perfect nail cover.Īlways remember to apply base, polish and top even on the tip of the nail (on thickness), this technique will ensure you an impeccable hold.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |